After the Concrete Cross Check has finished, the calculation of the bar positioning takes place. The results of the bar position are represented in the window "Bar position" with a table for every type of reinforcement (Top, Bottom, Surface, Hairpins, Stirrups).
The table Hairpins is filled based on the bending moments envelope and the bearing capacity. In this table you can change the results of the bar position. Every bar has its own label. In case of bend bars, the radius is available in the column Radius. The total length of the bar is represented in the column Total length. The results of the code check of the bar position are shown in the last column of the table. When the bar is not positioned correctly, Results comes up with the message Not OK. This is explained in the tooltips of the last column.