After Concrete Cross Check is finished, the calculation of the bar positioning takes place. The results of the bar position are represented in the window "Bar position" with a table for every type of reinforcement (Top, Bottom, Surface, Hairpins, Stirrups).
The table Surface is based on the bending moments envelope and the bearing capacity. In this table you can change the results of the bar position. Every bar has its own label. The necessary anchor length is represented in the column Anchor and the total length of the bar is represented in the column Length. The results of the code check of the bar position are shown in the last column of the table. When the bar is not positioned correctly, results come up with the message Not OK. It is explained in the tooltips of the last column.