Telecommunication

Telecommunication check

Telecom design check should comply with the below maximum allowable design value of the vertical rotation angle of a structural node, where antenna structure is braced. The design value of the vertical rotation angle of a node should be calculated with a reference period of one year and be less than following limit values:

 

 

Maximum allowable vertical rotation angle

Antenna

1.0°

Microwave

0.7°

 

Telecom check is possible in case all of the following conditions are satisfied:

  1. Technical module No. 176 (Wind load 1D Elements) is enabled;
  2. Structure is design using the structural steel material;
  3. Characteristic loads combination(s) are generated or/and defined manual way;
  4. Results are calculated.

 

Telecom design check is only performed on the structural nodes, where antenna structure(s) is braced. Such a braced structures is seen as the nodal concentrated loads defined or/and generated in the load definition part.